Mount .iso files under windows XP
This free program for Windows XP lets you create a virtual CD
drive on your hard disk.
winxpvirtualcdcontrolpanel_21.exe
For anyone unfamiliar with the terms 'virtual CD' or 'CD emulator', they mean that you can copy the entire contents of a CD-ROM to your hard disk and run the programs or access the files without the need for the original CD. This can make files more accessible, faster and more convenient. Given the speed and size of today's hard drives, you could easily fit a number of CDs onto your hard drive without noticing the difference. Assuming you had 30 full CDs, these would take around 20GB on a hard drive and all will be accessible after a few clicks of a mouse.
Hard drives are about 10 times faster than a CD, plus you can instantly access the file instead of grabbing the CD case, inserting the CD and awaiting for the contents to load. It's true, you could try copying the files over to the hard drive, but this can get messy, plus some programs require a CD to be loaded in order to run. This virtual CD program 'pretends' it is a CD drive (even though the files are on your hard drive), so your programs will run as normal.
It only works with ISO images
Installation instructions
=========================
1. Copy VCdRom.sys to your %systemroot%system32drivers folder.
2. Execute VCdControlTool.exe
3. Click "Driver control"
4. If the "Install Driver" button is available, click it. Navigate
to the %systemroot%system32drivers folder, select VCdRom.sys, and click
Open.
5. Click "Start"
6. Click OK
7. Click "Add Drive" to add a drive to the drive list. Ensure that
the drive added is not a local drive. If it is, continue to click "Add
Drive" until an unused drive letter is available.
8. Select an unused drive letter from the drive list and click "Mount".
9. Navigate to the image file, select it, and click "OK". UNC
naming conventions should not be used, however mapped network drives
should be OK.
You may now use the drive letter as if it were a local CD-ROM
device. When you are finished you may unmount, stop, and remove the
driver from memory using the driver control.
Posted by mark at April 13, 2005 04:03 PM
| TrackBack